Holder Only Sold without products
Features Designed to hold our luxury 240ml glass and 300ml plastic range of products. If purchasing our holders for another brand please check your bottle dimensions are within our guide shown below 'Bottle Sizes'.
Lockable, with unique drop down feature for easy cleaning and loading.
Recommended For both commercial and residential use.
Features Our security double holder will hold most 250-300ml round bottles with it's unique drop-down design, fully lockable.
Material 2.5/2mm stainless steel in Antique Bronze powder coated finish.
Dimensions Back plate: L x 135mm W x 102mm D x 68mm. Space required to include loading of bottle due to front plate sliding downwards: L x 155mm W x 125mm.
Bottle Sizes Suitable for bottles sizes 58-62mm in diameter and 110-120mm in height (to top of shoulder). The bottle neck size cannot exceed 28mm.).
Fixing Instructions For Single, Double and Triple Wall Mounted Holders.
Your holder is made from 304 certified stainless steel and should not rust but care needs to be taken when installing and cleaning your holders.
Hand Basin Location Fit allowing suitable height above and below holder for access for re-filling and changing the bottle. Recommended minimum height from work surface to bottom of holder = 10cm.
Shower Location If possible, locate the holder arms reach from shower head, not directly beneath it. We recommended a minimum height of 100cm from floor to bottom of holder and if possible fit dispenser into a corner so not to be a hazard.
Fixing Remove Holder from bag and use as template to mark wall, drill using appropriate drill bit and fit plug, attach holder to wall.
Holders can be stuck to clean even surfaces using a good quality double sided tape as provided.
Make sure surface is dry and clean, use alcohol wipe provided to wipe surface and allow to dry. Once stuck, allow as much time (up to 24hrs) for adhesive to set before positioning bottles into dispenser.
1) Loosen screws with allen key, make sure front plate is fully down.
2) Load bottles by positioning pumps through large holes in top of holder.
3) Once bottles are positioned on front/base plate, slide plate up with bottle pumps through holes as far up as possible, tighten allen screws.
SoHo Dispensers does not install holders nor guarantees any of the fixing or tape supplied, due to different surfaces types.
Cleaning For care of your holder, we recommend removing bottles monthly and clean thoroughly using a micro fibre cloth and soapy water. If positioned in hard water areas, vinegar is recommended for removal of lime scale. Harsh chemicals or abrasive cleaners should not be used to clean these holders.
SoHo Dispensers does not guarantee their holders against misuse of cleaning.
For maximum presentation keep bottles topped up at all time.
Made in England